# # Configuration file for Laptop Mode Tools module lcd-brightness. # # For more information, consult the laptop-mode.conf(8) manual page. # ############################################################################### # LCD brightness settings # ----------------------- # # Using these settings, you can make laptop mode tools automatically adjust # your LCD's brightness settings. The settings are extremely simple -- they # only allow for the execution of a command, nothing more. The reason for this # is that LCD brightness settings are very different between laptop vendors. # # Suggestions for commands: # # * If your system has the file "/proc/acpi/video/VID/LCD/brightness" (VID may # be VID1 or similar), use this file as BRIGHTNESS_OUTPUT, and use # the command "echo <value>". The possible values can be listed using the # command: # # cat /proc/acpi/video/VID/LCD/brightness # # * If you have a file /sys/class/backlight/.../brightness, then you can use # that file as BRIGHTNESS_OUTPUT, and the command "echo <value>". # # As far as I understand it the values are between 0 and # the value contained in the file /sys/class/backlight/.../max_brightness. # # * For Toshiba laptops, use the command "toshset" with the -lcd or -inten # command. Read the toshset(1) manual page for more information on the # parameters for this command. If you use this command, set # BRIGHTNESS_OUTPUT to "/dev/null". # ############################################################################### ############################################################################### # # IMPORTANT: In versions 1.36 and earlier, these settings were included in the # main laptop-mode.conf configuration file. If they are still present, they # overrule the settings in this file. To fix this, simply delete the settings # from the main config file. # ############################################################################### # Enable debug mode for this module # Set to 1 if you want to debug this module DEBUG=0 # # Should laptop mode tools control LCD brightness? # CONTROL_BRIGHTNESS=0 # # Commands to execute to set the brightness on your LCD # BATT_BRIGHTNESS_COMMAND="echo [value]" LM_AC_BRIGHTNESS_COMMAND="echo [value]" NOLM_AC_BRIGHTNESS_COMMAND="echo [value]" BRIGHTNESS_OUTPUT="/proc/acpi/video/VID/LCD/brightness"