# # Default settings for IPPP # Put common settings here, and special settings in the profile files # #### ISDN Config settings # Config name I4L_PROFILENAME="IPPP-Default" ### ISDN Device settings # name of master device DEVICE="ippp0" # name of slave device for multilink ppp # SLAVE=slave0 # Bootmode ONBOOT="no" ### ISDN PPP settings # Remote username #I4L_USERNAME="linuxlogin" # Remote systemname #I4L_SYSNAME="linuxisp" # Local systemname #I4L_LOCALNAME="linuxbox" # PPPoptions I4L_PPPOPTIONS="noipdefault ipcp-accept-local ipcp-accept-remote -vj -bsdcomp noccp" # PPPBind I4L_PPPBIND="yes" ### ISDN phone settings # my phone number #I4L_LOCALMSN="33333333" # remote station phone numbers dialout ("111111 222222 333333") #I4L_REMOTE_OUT="11111111 22222222" # remote station phone numbers dialin ("2222222 1111111 333333") #I4L_REMOTE_IN="1111111 2222222" ### ISDN link settings # Ondemand dialmode ("off" "manual" "auto") I4L_DIALMODE="manual" # dialmode for SLAVE ("off" "manual" "auto") (usually auto, as recommended by i4l FAQ) I4L_DIALMODE_SLAVE="auto" # Ondemand idletime before hangup (in seconds) I4L_IDLETIME=180 # hangup befor next charge info ("on" or "off") # this only works, if your isdn-provider transmits the charge-info during # and after the connection # it does NOT work with the Teles on an EDSS1-Line :-( I4L_CHARGEHUP=off # hang-up-timer for incoming calls ("on" or "off") I4L_IHUP=off # Set the number of dial atempts for each number # set to "" for unlimited I4L_DIALMAX=3 # secure # "on" = only defined numbers are allowed to call in # "off" = all numbers are allowed to call in I4L_SECURE="on" # callback ("on", "off", "in" or "out") # the other host must accept this I4L_CALLBACK="off" # callback delay in seconds (default: 5) I4L_CBDELAY=5 # activ hangup when getting an incoming call (default: "on") I4L_CBHUP="off" ### ISDN protocol settings # layer-2 protocol (default: "hdlc") # With the ICN-driver and the Teles-driver, "x75i" and "hdlc" is available. # With other drivers, "x75ui", "x75bui" may be possible too I4L_L2="hdlc" # layer-3 protocol (only "trans" is allowed) I4L_L3="trans" # encapsulation # possible values: "rawip" (default), "ip", "cisco-h", "ethernet", # "syncppp", "uihdlc" # see: /usr/src/linux/Documentation/isdn/README I4L_ENCAP="syncppp" ### ISDN Network settings # my ip address #IPADDR="192.168.100.1" # remote ip address #REMOTEADDR="192.168.100.2" # Remote netmask #NETMASK="255.255.255.0" # Remote networkaddress #NETWORK="192.168.100.0" # Remote broadcast #BROADCAST="192.168.100.255"