# /etc/cpuspeed.conf # # This configuration file controls the behavior of both the # cpuspeed daemon and various cpufreq modules. ### DRIVER ### # Your CPUFreq driver module # Note that many drivers are now built-in, rather than built as modules, # so its usually best not to specify one. The most commonly-needed driver # module these days is 'p4-clockmod'. # default value: empty (auto-detect/use built-in) DRIVER= ### GOVERNOR ### # Which scaling governor to use # Valid scaling governors for your cpu(s) can be found in # /sys/devices/system/cpu/cpu*/cpufreq/scaling_available_governors # on systems that support frequency scaling. # NOTES: # - The GOVERNOR parameter is only valid on centrino and powernow-k8 (amd64) # platforms, other platforms that support frequency scaling always use # the 'userspace' governor. # - Using the 'userspace' governor will trigger the cpuspeed daemon to run, # which provides said user-space frequency scaling. # default value: empty (defaults to ondemand) GOVERNOR= ### FREQUENCIES ### # NOTE: valid max/min frequencies for your cpu(s) can be found in # /sys/devices/system/cpu/cpu*/cpufreq/scaling_available_frequencies # on systems that support frequency scaling. # maximum speed to scale up to # default value: empty (use cpu reported maximum) MAX_SPEED= # minimum speed to scale down to # default value: empty (use cpu reported minimum) MIN_SPEED= ### SCALING THRESHOLDS ### # Busy percentage threshold over which to scale up to max frequency # default value: empty (use governor default) UP_THRESHOLD= # Busy percentage threshold under which to scale frequency down # default value: empty (use governor default) DOWN_THRESHOLD= ### NICE PROCESS HANDLING ### # Let background (nice) processes speed up the cpu # default value: 0 (background process usage can speed up cpu) # alternate value: 1 (background processes will be ignored) IGNORE_NICE=0 ##################################################### ########## HISTORICAL CPUSPEED CONFIG BITS ########## ##################################################### VMAJOR=1 VMINOR=1 # Add your favorite options here #OPTS="$OPTS -s 0 -i 10 -r" # uncomment and modify this to check the state of the AC adapter #OPTS="$OPTS -a /proc/acpi/ac_adapter/*/state" # uncomment and modify this to check the system temperature #OPTS="$OPTS -t /proc/acpi/thermal_zone/*/temperature 75"